![]() ![]() FII RISC-V3.Performance Evaluation of FII RISC-V3.01 on FII-PRX100-D (ARTIX-7, XC7A100T) XILINX FPGA Board.corresponds to the USB port on the development board.įinally, we can see the network information below that with Net and eth0. They all use serial ports as their terminals. ![]() The next few lines display the terminals for standard input, output, and error. SF displays the detection of QSPI –s25f1128s, with the size of 16MB. As we can see, we have one card connected. MMC refers to the MMC/SD cards that are connected. The U-Boot version is displayed at the very top, followed by the details regarding the development board.īelow, we can see that DRAM (RAM) is set to 1 gigabyte. Note the long list of information displayed prior to the stop autoboot prompt. Afterwards, the system should go into U-Boot commands as shown by the zynq> in the command line. When your development board starts up, make sure you stop the autoboot process by pressing any key within 4 seconds. Because we deal with embedded development, we will be using the most widely used U-Boot, which stands for Universal Boot Loader. Similar to how Windows systems have BIOS settings that can be accessed before the system boots up, Linux makes use of its very own Bootloaders. You will also need to have your development board connection already set up, along with your TFTP server. The i.MX 8 pre-built images or Yocto Project default. On i.MX 8, the U-Boot cannot boot the device by itself. GPIO are specified in bank and IO in this manual. By default, Edison’s UART port is used for u-boot console. U-Boot can be used to load a U-Boot image onto some other devices. To accomplish this you will take the board design from your HW team and use the AM335x EVM and accompanying Sitara Linux SDK and port U-. Boot to the full operating system for more GPIO support. One of the image’s components is u-boot with an Edison-specific patch. U-Boot can be loaded directly onto an SD card using the Linux dd command. As explained before, the kernel is compressed and will decompress itself, thus theres no need to compress in the FIT. The manufacturing tool can be used to load U-Boot onto all devices with i.MX 6 and i.MX 7. bbappend to the kernel recipe to make a new package containing these). Because this tutorial is geared towards Ubuntu 16.04.01, using other versions may have differences between the execution of commands. To create the FIT image, I needed my initrd (optional), arch/x86/boot/vmlinux.bin, and arch/x86/boot/setup.bin from a successfully built kernel (I added a. *In order to follow along to this tutorial, you will be required to have Ubuntu 16.04.01 already installed on your Virtual Machine using Oracle’s VirtualBox. This article briefly introduces U-Boot and how to use it.įor related subjects, please refer to the SOC Table of Contents. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |